Chevron conveyor belts improve conveyor productivity by preventing the roll back of materials when operating on steep inclines.
Our range of chevron conveyor belts are designed to improve operational efficiency and throughput of material when you’re conveying on an angle greater than 18 degrees.
Chevron conveyor belts are specially designed to cope with the frequent flexing required during use. As well as preventing the rollback of materials, they save space (due to a smaller footprint), increase carrying capacity, provide a reduction in structural and power consumption costs, reduce spillage and material loss, and have a flexible belt construction that can wrap around small pulleys.
We have over 8km of chevron conveyor belting onsite and readily available. As the largest stockist in WA, we have a variety of profiles available to suit a wide range of applications. They also come with wear-resistant covers and cleats to provide a high service life. Popular profiles are outlined in the table below:
| Profile | Belt Width | Cleat Width | Cleat Height | Uses |
| Sergeant | 350-900mm | 350-900mm | 6mm | Low to moderate inclines. |
| V-Cleat | 450-1200mm | 385-750mm | 15mm | Good all-round performance for moderate inclines. |
| Bull Horn | 1200-1600mm | 1000mm | 25mm | Heavy industrial applications with inclines over 28 degrees. Suitable for lump sizes up to 30mm. |
| Multi-V | 1830mm | 1830mm | 6mm | Low to moderate inclines with a high-speed output. |
Chevron conveyor belts are commonly used in stone aggregate handling, limestone conveying in cement plants, scrap handling and wood chips. They’re also used in agriculture for conveying grain or canola seeds.
Contact our sales team on +61 8 9370 5577 or enquire here for more information about our chevron belts.
| Common Widths | Refer to Technical Information Sections |
| Belt Length Range | ‘L’-160m, ‘H’-120m |
| Carcass Variety Available | EP |
| Common Belt Rating | 200 to 800 KN/M |
| No. of Plies | 2ply to 4ply |
| Rubber Cover Grades | N / M / SAR / HR / OR |
| Rubber Cover Thickness | Min. 3.0mm top and 1.5mm bottom or bare back |
| Rubber | Black |
| Surface Finish | Cleat on top Covers only |
| Edge | Cut or Moulded Edge |
| Splicing Method | Hot Splice / Cold Splice / Mechanical Splice |
